A) Check that the lever located on the back of the machine is set to "slow" (or "snail").
B) Check that the switch under the rubber lever controlling the hammer is set to "automatic".
C) Check that the lever located on the inner left side of the frame is set to "tracks/castle", facing the front of the machine.
D) Check that the green light on the control panel is on.
E) Check that the red LED on the 12V socket, to which the load cell is connected, is on.
F) Check that all fuses, located at the rear of the machine inside the battery compartment, are intact.
If the value continues to be low, we kindly invite you to contact our 24-hour support service through the following link: https://support.pagani-geotechnical.com/hc/it
If you prefer to receive assistance during office hours, please fill out the form available at the following link: https://support.pagani-geotechnical.com/hc/it/requests/new